Galvanize Double Wire Chain Link Fence Weaving Machine Not Easy
Corrode Long Life
Chain link fence machine is specially used for manufacturing chain
link fences of different sizes. The wire is taken in from the
pay-off and pass through the mould where the DIAMOND SIZE takes
place. After passing through the mould, the diamond pattern wire is
automatically thrown on the winding shaft in the switching process.
Once the switching is complete,the woven is manually glided down to
enable the next switch to take place.
The chain link is automatically wound to form rolls when the
desired length is manufactured.
The machine is controlled by PLC automatic controller, so only one
person is needed to operate it.
One side or both sides of the end of mesh hole is twisted or with
burr in edge.
Finally,according to the practical need,can use the compacting
machine to make the chain link fence mesh into the smaller and
1. The production efficiency is about twice of the same species.
2. The fault is the lowest in the same species.
3. The machine is easy and simple to handle.The worker has the
common mechanical knowledge can master it in one hour.
4. The loss of the raw materials of the same species is 5%-7%,
while the chain link fence machine is nearly zero.
5. The electrical energy the chain fence link making machine can
save is about20%.
6. It is suitable to all kinds of mild steel wires.
Chicken fence, poultry fence and zoo enclosure, construction,
mechanical equipment protection, sports ground fence, railway
guard, green belt fence,etc.
|Woven wire diameter||1.5-4.5mm|
|Main machine power||5.5kw|
|Weaving machine power||1.5KW|
|Border wire treating machine power||0.75kw*2|